How do you stack small square bales on a wagon?

How do you stack small square bales on a wagon?

To increase airflow, it’s recommended that at least the bottommost layer of bales should be stacked on their cut sides, in such a way that the baling twine does not touch the floor. All subsequent layers can then be stacked flat with the baling twine facing up.

How many bales does a stack wagon hold?

The Stackcruiser 103 handles 16” x 18” two-tie bales and a variety of three-tie bales with a bale capacity of 82. Both models can handle large square bales too.

Does New Holland still make bale wagons?

We have been rebuilding and operating New Holland bale wagons since 1968. Since then we have operated and worked on almost every bale wagon model that New Holland has made – over 25 types of unique bale wagons! We’re a small team of dedicated, local Montanans.

How tall is a bale wagon?

Stackcruiser 102

Standard Optional
Stackcruiser® 102
Stack
Maximum height cm (in) 411 (162), w/41 cm x 46 cm (16 in x 18 in) bales
Maximum width cm (in) 213 x 312 ( 84 x 123) w/36 cm x 46 cm ( 14 in x 18 in) bales, 244 x 312 ( 96 x 123) w/41 cm x 46 cm ( 16 in x 18 in) bales

What is the proper way to stack hay bales?

Always stack hay with cut side down. That means the strings will always be on the side of the bale when you look at the stack. Not only does this deter mice from gnawing on the strings of the bale, it also allows moisture to run down through the stack to the bottom layer.

How high can you stack square bales?

30 feet

“This gets really important when the stack gets 20 layers high,” said Schultheis. Three, for stability, make sure the stack height does not exceed 1.5 times the shortest base dimension. For example, if the stack is 20 feet wide and 40 feet long, the height should not exceed 30 feet.

How do you stack square bales of hay on a trailer?

How To Stack Square Bales On A Flatbed Truck Properly – YouTube

How many bales does a bale basket hold?

approximately 100 bales
The standard basket capacity is approximately 100 bales and unloads by gravity, “more free energy.” A simple trip lever releases the rear gate latch and in a matter of seconds the basket is ready to load up again. Options available: 3′ 30 bale extension, center hitch for N.H. balers.

How much does a loaded hay wagon weigh?

All of this hay needs to be transported from its point of origin to the farm. Loads of hay on hay wagons can typically weigh between six and eight tons.

How wide is a hay wagon?

For centuries now, hay wagons have been one of the most essential pieces of farm equipment.

Model Dimensions Height w/ sides
BW818WS 8′ x 18′ 129″
BW822WS 8′ x 22′ 129″
BW918WS 9′ x 18′ 129″
BW922WS 9′ x 22′ 129″

How does a bale accumulator work?

Norden Mfg Hay Accumulator System – YouTube

How long should hay sit before stacking?

Hay baled with more than 22 percent moisture should probably not be put into storage for at least 30 days. This is especially true if bales are to be stacked several layers deep. With the threat of barn fires removed by outside hay storage, many operators of large round balers try to bale hay with too much moisture.

How do you stack hay bales on a wagon?

Running Square Baler and Stacking Wagon Alone – YouTube

What is the best floor to store hay on?

Most barns designed for storing large round bales simply use a dirt floor that is elevated and well drained to minimize moisture intrusion. Some barns that store valuable hay (typically small square bales for the horse market) do use a concrete floor.

How do you stack hay safely?

Alternate layers so that there is a clear overlap of roughly half a bale all around the stack. Don’t stack any higher than 1.5x the width of the base. Don’t stack more than ten bales on hard-standing or concrete. Don’t stack more than eight bales where there is no hard-standing available.

How do you make a hay stack?

Dig a hole in the ground about 2 foot deep and set the center pole in and tamp dirt around it. Cut three or four notches in the center pole about 4′ up the pole. Just a small notch will do fine. Dig four holes about a foot deep and place the supports in these holes leaning them into the notches in the center pole.

How do you load square bales?

How to Stack Square Bales in a Pickup – YouTube

What is the standard size of a hay wagon?

How fast can you drive with a hay wagon?

If you have the horsepower, there is almost no limit to how fast you can drive through the field. Speeds of up to 15 mph or more are feasible, though very few tractors can do this safely.

How much weight will a hay wagon hold?

WG SeriesConventional Wagon Gears

Model Capacity Weight w/o Rims
WG88 16,000 lbs 510 lbs
WG98 16,000 lbs 585 lbs
WG108 20,000 lbs 675 lbs
WG1208 24,000 lbs 940 lbs

How do you make a wooden hay wagon?

Building a Hay Wagon – YouTube

What is a hay bale accumulator?

Parrish Agriturf Small Bale Hay Accumulator
The small bale accumulator is designed to eliminate labor. This unit is designed to allow to one man to clear and accumulate an entire field of hay in just a fraction of time.

How does a Hoelscher bale accumulator work?

As the baler pushes the bales onto the accumulator, a pivoting arm automatically lifts two bales at a time and puts them on the bed, while turning them a quarter turn. By turning the bales on edge, hay spoilage and mold is reduced, and the bales will keep their shape better.

Can hay be too dry to bale?

When hay is too dry before baling, the leaves of the forage become stiff and brittle, making them much more likely to fall off. In many cases, a significant portion of hay’s nutritive value lies in the leafy portions of the herbs used to make the hay.

How soon can you stack hay after baling?

Hay baled with more than 22 percent moisture should probably not be put into storage for at least 30 days. This is especially true if bales are to be stacked several layers deep.

Related Post