What is controlled access zone?
Controlled access zones are designed to provide added safety for workers in elevated areas of the worksite. The U.S. Occupational Safety and Health Administration (OSHA) requires employers to maintain fall protection safety measures to protect employees in all areas where falls of six feet or more are possible.
What type of work is commonly done in a controlled access zone?
A controlled access zone is most typically used for jobs requiring workers to be on a leading edge. Examples of this might include some types of masonry and bricklaying. In overhand bricklaying, for example, the leading edge shifts as the job progresses and there is often nowhere to install an anchorpoint.
When can a controlled access zone be used?
In summary, you may only use a controlled access zone for leading edge work if all of the safety systems listed in §1926.501(b)(2)(i) are either infeasible or create a greater hazard. The controlled access zone must be part of an alternative fall protection plan that complies with §1926.502(k).
What is a control zone in fall protection?
The use of a control zone is an approach to fall protection for workers performing work on a level working surface within 2 metres of an unguarded edge above a surface or thing that could cause injury to the worker if the worker were to fall on the surface or thing.
What is a control zone for work at height?
What Is a Control Zone? A control zone is the interior part of a large low-rise roof (4 degrees horizontal rise or less, according to Alberta Labour), which is at least 2 metres in from the edge.
What is a control zone for work at heights?
What is fall distance?
Total fall distance is the total distance of a free fall, plus the additional distance encountered during deceleration.
What is a controlled access zone?
A controlled access zone is a safety measure for workers at heights where guardrails or fall arrest equipment are not able to be used. OSHA requires employers to implement fall protection measures for employees working at heights of six feet or more.
Can a controlled access zone be used for leading edge work?
Re: Clarification on controlled access zones for leading edge work. Question: When using a controlled access zone for leading edge work where one side has no wall or guardrail system to which a control line can be connected, is it permissible to tie control lines to temporary guardrail stanchions 10 feet off the leading edge?
What does the OSHA clarification letter say about controlled access zones?
Clarification on controlled access zones for leading edge work. OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations.
Why is proper training and monitoring important in controlled access zones?
Proper training and monitoring is required to ensure that workers are protected against falls in controlled access zones and other areas of the workplace. Maintaining safe working practices is of critical importance in these relatively unprotected areas.