How do I erase a Cisco router configuration?
Enter configure terminal to go to Global Configuration Mode. Enter config-register 0x2102. Enter end, and then enter the write erase command to delete the current startup configuration on the router. Enter reload to reload the router.
What is the default password for a Cisco switch?
Most routers and switches by Cisco have default passwords of admin or cisco, and default IP addresses of 192.168. 1.1 or 192.168. 1.254. However, some differ as shown in the table below.
How do I reset my Cisco Catalyst 2950 to factory settings?
If indeed the switch has a MODE button on the front panel, Step 1: turn off/on the switch while holding the button down for roughly 15 seconds. Step 2: You will be able to view the led lights blink, and now the switch should have reset to default on system restart once you release the mode button.
What is the factory default setting for the configuration register on Cisco routers?
The factory-default setting for the configuration register is 0x2102. This indicates that the router should attempt to load a Cisco IOS software image from Flash memory and load the startup configuration.
What is the default setting of Cisco router?
The Router reloads and is set to the default configuration settings. Step 2. Login with the default credentials. The default username is cisco and the default password is cisco.
Can you factory reset your router?
To reset your router: Locate the Reset button on the back of your router. With the router powered on, use the pointed end of a paperclip or similar object to press and hold the Reset button for 15 seconds. Wait for the router to fully reset and power back on.
How to reset Cisco router to factory defaults?
With the router powered off,connect the power cord to your router,and plug the power cord into your power source.
How to disassemble Dell Vostro 3560?
Dell Vostro 3560 disassembly. Ok guys, so, I’ve got to the motherboard and the fan, and I want to clean my fan. But it seems like I cant pull my fan off if I don’t remove motherboard as well. I’m afraid of the motherboard so I want to post a picture here and you can go in paint and point what I need to do. Thanks in front.
How to enable IPv6 support on a Cisco 3560 switch?
– default —Set the switch to the default template to balance system resources. – routing —Set the switch to the routing template to support IPv4 and IPv6 routing, including IPv4 policy-based routing. – vlan —Maximize VLAN configuration on the switch with no routing supported in hardware.
How to reset brocade switch to factory defaults?
Set configuration parameters back to factory default settings. Disable the switch using the command switchdisable.