Is a C4 transmission a good transmission?

Is a C4 transmission a good transmission?

The most reliable automatic transmission Ford has ever produced has been the C4 Cruise-O-Matic. The C4 is a simple three-speed automatic transmission you can rebuild in your home garage with common hand tools.

Is it hard to rebuild a C4 transmission?

Ford’s C4 Cruise-O-Matic transmission is the most reliable automatic Ford has ever produced. It is simple by design. In fact, it is so simple you can tear it down and rebuild it in your home garage using the Ford Shop Manual because no special tools are required.

How do you check the end play on a C4 transmission?

Let me do it again push the input shift back in zero the gauge zeroed. And then pry again and 10 20 maybe 20 mm again that puts it right in the middle of the spec. That’s.

How much HP does a C4 do?

The Chevrolet Corvette (C4) is a sports car produced by American automobile manufacturer Chevrolet from 1983 until 1996. The convertible returned, as did higher performance engines, exemplified by the 375 hp (280 kW) LT5 found in the ZR-1.
…

What’s better C4 or C6 transmission?

While both are used by hot rod and drag racers enthusiasts, the C6 has gained favoritism when it comes to offroad driving. The C4 is not quite suitable for off-road since it cannot handle as much power as the C6 and as such, it was mostly used in cars and not trucks.

Can you add overdrive to a C4 transmission?

Overdrive is another popular upgrade with a late-model AOD automatic or a five/six-speed manual. But you can also upgrade to a Gear Vendors overdrive for your C4/C6 automatic or four-speed Top Loader transmission.

Which is better C4 or C6 transmission?

Why is it important to perform an end play check of an automatic transaxle?

The end play allows room for the formation of an oil film, misalignment, and thermal expansion of the bearing components.

How is transmission end play measured?

How to check transmission end play. – YouTube

How can I make my C4 faster?

Therefore, to make your C4 faster, we can apply this concept of ditching unnecessary weight…these are your free mods.

1. 1) Remove the Frisbee.
2. 2) Eliminate the muffler.
3. 3) Air smog pump eliminator.
4. 4) Spare tire removal.
5. 5) Performance Cold Air Intake.
6. 6) Throttle Body Coolant Bypass.
7. 7) Throttle Body AirFoil.
8. 8) Headers.

How heavy is a C4 transmission?

130 lbs

Weight. Ford C4 is a medium-duty transmission judging from its lightweight of 130 lbs dry w/ torque converter and its design with an aluminum case.

Is a Cruise O Matic a C4?

The Ford-O-Matic was manufactured from 1951 until it was replaced by the C4 in 1964.

What years did Ford use the AOD transmission?

The AOD (automatic overdrive) is a four-speed automatic transmission, with the 4th gear as overdrive. Introduced in 1980, it was Ford’s first four-speed automatic overdrive transmission.
Ford AOD transmission.

What is transmission end play?

Manufactures incorporate endplay into shafts to provide for heat expansion, to lubricate, and to compensate for imperfections that may occur. All automatic transmissions have at least two shafts.

What is a end play?

Definition of end play (Entry 2 of 2) 1 : to execute a throw-in when playing (a bridge hand) 2 : to force (a bridge opponent) to win a trick and make a subsequent lead unfavorable to him.

Why is it important to perform an end play check of an automatic transmission?

Are C4 Corvettes fast?

Item: It is hands-down the fastest American automobile, capable of 140-mph top speeds, 0-to-60 times under seven seconds, and 15.2-second quarter-mile forays at 90 mph. In fact, these figures qualify the Corvette as one of the half-dozen fastest production automobiles in the entire world!

How much horsepower can you get out of a C4 Corvette?

It’s hard to pinpoint exactly how much horsepower a tune will give you. With no performance mods installed, you should expect a 15-20 hp gain. However, with performance mods installed, you can expect hp gains of 30, 40, 50, and much much more. Make sure you go to a skilled tuner.

What engines fit a C4 transmission?

It was primarily used with Ford’s inline six-cylinder engines and small V8 engines (see Ford small block engines), usually up to 302 in³ (5.0 L). By comparison, the 351 Windsor and 351 Cleveland small and intermediate-block engines were backed by the medium-duty FMX or the heavy-duty C6 that debuted in 1966.

How many gears does a C4 transmission have?

three-speed
The Ford C4 is a three-speed, medium-duty automatic transmission introduced on 1964 model year vehicles and produced through 1981. The C4 was designed to be a lighter and simpler replacement for the original Ford-O-Matic two speed transmission being used in smaller, less powerful cars.

Did Ford make a 2 speed transmission?

The Ford-O-Matic two-speed transmission was introduced in 1959. A simplified version of the Cruise-O-Matic, it combined a torque connector and a compound planetary gear set.

How much end play should a crankshaft have?

0.004 to 0.005-inch
Generally speaking, keeping the thrust clearance at 0.004 to 0.005-inch is appropriate but it is best to check the recommended clearance. For example, late model engines prefer a slightly tighter clearance to minimize travel of the crank sensor reluctor wheel.

How do you check End play shaft?

checking Crankshaft end play – YouTube

What causes excessive crankshaft end play?

If there’s excess endplay on a fresh motor, it may be because the block and crank weren’t properly dressed or ground in the thrust area, the crank is bent, or the main-bearing thrust cap and journal are cocked (usually because the line hone is off).

What causes a crankshaft thrust bearing to fail?

Thrust bearing failure can be caused by a variety of things including insufficient or excessive crankshaft end play, a ballooned torque converter, or stress caused by excessive clutch use.