What is ATF G?
Automatic Transmission Fluid : Carlube Driveline ATF-G. Main navigation. Oils & Lubricants/ Transmission Fluids/ Automatic Transmission Fluid.
What is the viscosity of ATF oil?
Automatic Transmission
Transmission Fluid is essentially thin hydraulic oil. In order to effectively lubricate the delicate parts of the system, the viscosity of the oil is kept low – generally around 0W/5 or 5W/10.
What is ATF Type F oil?
Valvoline Type F ATF is an automatic transmission fluid that has been uniquely engineered to meet and exceed the requirements of older Ford and select import vehicles with automatic transmissions and is officially licensed and approved by Ford.
What is ATF Type A?
ATF Type A is a quality economical fluid. It is formulated from select base oils with a special additive to suppress foam formation. It contains red dye as a leak detector. Type A Automatic Transmission Fluid provides straight mineral oil lubrication and can be used when a lubricant of this type is recommended.
Are all ATF fluid the same?
A simple answer is NO, all transmission fluids are not the same. Different types of fluids are used for different types of transmission. A car transmission can either be manual or automatic. Fluids used for automatic transmission cannot be used for manual transmissions and vice versa.
Is it good to change transmission fluid on high mileage?
Changing the transmission fluid on a high-mileage car is risky. Don’t do it unless your transmission is running fine and the fluid is first-rate, because it can make transmission failure imminent.
What is the viscosity of Dexron ATF?
It is concluded that the current used-fluid Dexron viscosity limit of 5.5 cs minimum at 210 F provides a good safety factor for preventing excessive internal leakage at high temperatures.
What can I use instead of Type F transmission fluid?
This type of drive train fluid should not be used in automatics that require Type F. It can be replaced with Mercon or Mercon V specification.
Is ATF and Type F the same?
Ford first produced its own ATF in 1967 and referred to as Type F. The name comes from Ford’s specification number for the fluid, ESW M2C33-F. This fluid was used in all Ford transmissions until 1977 and most Ford transmissions until 1980.
Can you mix Type A and Type F transmission fluid?
Type F is not compatible with any other ATF. Specifically, it is not compatible with Mercon ATFs.
Is Dexron type A?
Dexron (B) is the first generation of automatic transmission fluids. They were produced after Type A transmission fluid in the mid-60s. When you compare type A transmission fluid vs. Dexron, we will find that Dexron (B) was composed of a more stable, less reactive, and hydrotreated base oil.
Can I mix different brands of ATF?
Yes. Synthetic ATF and conventional fluids are 100 percent compatible with each other.
What happens if you mix different types of transmission fluid?
The most common situation where the wrong transmission fluid is used is in the case of using automatic transmission fluid in place of variable transmission fluid and vice versa. Adding ATF to a to a CVT will eventually result in the death of your transmission.
What are the signs that you need a transmission flush?
Here’s a look at five signs that it’s time for a transmission flush.
- Gears Slipping. If your transmission fluid is old and dirty, then contaminants could block the fluid’s flow, consequently resulting in a reduction in hydraulic power.
- Issues with Shifting Gears.
- Stalling Out.
- Lunging.
- Grinding Sounds.
Is it OK to change transmission fluid without changing the filter?
Many transmission manufacturers use only a screen on the fluid pickup to filter out any casting flaws or debris that could be poured down the dipstick. Some manufacturers do not recommend changing the filter. The fluid will break down and needs to be changed, the filters do not plug up on a healthy transmission.
What transmission fluid is equivalent to Dexron 3?
Dexron VI
Dexron VI replaced Dexron II and III, and can be used in General Motors domestically built or import transmissions that specified Dexron II or Dexron III. Dexron VI is a low viscosity transmission fluid and should also be used with the full synthetic low viscosity transmission fluid.
What viscosity is Dex 3?
GM: DEXRON-III, DEXRON-II, DEXRON-G34447.
…
Performance Specifications.
| TYPICAL PROPERTIES | ATF |
|---|---|
| KINEMATIC VISCOSITY CST @ 40°C | 37 |
| KINEMATIC VISCOSITY CST @ 100°C | 7.3 |
| VISCOSITY INDEX (D2270) | 173 |
Can you use Dexron in place of Type F?
As to ATF, no problem mixing Dexron and Type F, one can actually fine tune shift harshness as Type F is in fact “grippier”.
Is ATF the same as Type F?
General Motors referred to its ATF as Dexron II and Ford’s specified fluid was labeled Mercon. Ford first produced its own ATF in 1967 and referred to as Type F. The name comes from Ford’s specification number for the fluid, ESW M2C33-F.
Can you mix Dexron and Type F transmission fluid?
Is ATF the same as Dexron?
Dexron is the trade name for a group of technical specifications of automatic transmission fluid (ATF) created by General Motors (GM).
Can you still buy Type A transmission fluid?
They may notice on the dipstick or in the owner’s manual that the car requires an automatic transmission fluid, called Type A, that is no longer available. That’s because Type A Transmission fluid was put into older vehicles produced as far back as the 1950’s to lubricate automatic transmissions in the car’s engine.
What will happen if you use the wrong transmission fluid?
Using the wrong fluid can cause poor lubrication, overheating, and possibly transmission failure. A mechanic might not be able to reverse the damage, even by flushing the transmission. Mistakenly adding motor oil or brake fluid can also destroy your transmission.
What happens if you mix ATF?