What is the fastest balloon powered car?

The Winners

Table of Contents

Award Category	Driver Name	Winning Figure
Fastest	Dean/Debbie Oisboid	>10 feet per second
Largest	Mike Blakely	72 inches long
Smallest	Kim Aaron	5.5 inches long
Heaviest	Suzanne Balzer	3700 grams

What is the science behind balloon car?

The science behind this experiment is all about energy. When the balloon is inflated it stores the compressed air and stretched rubber as potential energy. When you let the air out of the balloon, the potential energy is converted into kinetic energy; this is the energy of motion, which is why the car moves.

What do you need to make a balloon powered car?

A balloon-powered car consists of three main parts: The body of the car (piece of cardboard or plastic bottle in Figure 1) The wheels of the car (CDs or plastic bottle caps in Figure 1) The axles, which connect the wheels to the body, and allow the wheels to spin (wooden skewers in Figure 1)

What makes a good gravity car?

In gravity vehicle, you must value both the accuracy and speed of your car. And the best way to make your car faster and more accurate, you want your wheels to sufficiently stabilize your vehicle while also being as light as possible.

What make a gravity car go faster?

how to improve your vehicle

add more weight to your vehicle. Contrary to other vehicle-based events, you should maximize the weight of your gravity vehicle.
use wider wheels.
Oil your axles.

How long should a gravity vehicle be?

The Competition Event supervisors will designate a distance between 9-12 meters as the target distance, or target point. The distance will be in 0.5 meter increments for regionals, 0.25 meter increments for states, and 0.05 meter increments for nationals.

What is a soap car?

A gravity racer or soapbox is a motorless vehicle which is raced on a downhill road either against the clock or against another competitor.

What is the fastest soap box derby car?

The speed record is held by Tommy Fisher, who covered the 953.9 feet in 26.30 seconds. Early winners kept coming back as fathers, then as grandfathers. Crowds grew. The Derby became Akron’s greatest annual show.

How do you make a balloon powered car?

How do you make a balloon powered car? Method 3 of 3: Building A Water Bottle Balloon Car. Clean out a plastic bottle. Cut two pieces of straws the width as your bottle. Tape the straws to the side of the bottle. Cut two skewers down to make the axels. Slide the skewers into the straws. Make some wheels. Attach the wheels.

How to make a balloon powered car very simple?

Put your car down on a flat surface and give it a good push.

Tape the neck of the balloon around one end of the other straw.

Cut a small hole in the top of the water bottle,just big enough to push the straw through.

Push the free end of the straw through the hole and out the mouth of the bottle.

Use tape to secure the straw to the bottle.

How to make a balloon powered car faster?

Each team is provided with a kit to construct their Balloon Rocket Car.

Teams are to select a nozzle (vinyl tubing) size and wheels they would like to use on their car.

Each team should select an individual in charge of blowing up their balloon.

Assemble the Chassis and Suspension:

Assemble the Motor:

Make your way over to the test track.

How to power a toy car with a balloon?

– The straw is the back of the car. The balloon is the front. – If the balloon is not holding air, there may be a gap. Wrap some more tape around the end of the balloon. – If the balloon still is not holding any air, it might have a hole in it. Get a new balloon.

What is the fastest balloon powered car?