How do I fix error code P0342?

How do I fix error code P0342?

What repairs can fix the P0342 code?

  1. Recharging or replacing the battery.
  2. Repairing or replacing the starter motor.
  3. Repairing or replacing any faulty wiring or connectors.
  4. Replacing a defective camshaft position sensor.

What does error code P0342 mean?

P0342 is a diagnostic trouble code (DTC) that stands for “Camshaft Position Sensor ‘A’ Circuit Low.” It basically means that your PCM is not detecting a correct signal from your camshaft position sensor. Designation “A” refers to the sensor located in Bank 1, which has your engine’s cylinder #1.

What is a P0335 code?

The OBD-II code P0335 is a generic diagnostic trouble code that stands for “Crankshaft Position “A” Circuit Malfunction.” The code is set when your car’s primary computer—also known as the powertrain control module (PCM)—is unable to detect a signal from the crankshaft position sensor.

Can you drive with code P0335?

Other Notes About P0335 You shouldn’t continue to drive your vehicle once it triggers this code. An issue with the CKP can cause your vehicle to stall—and that can be dangerous. Get your car diagnosed immediately if you run into this trouble code (or the related trouble codes P0336, P0337, P0338, etc.).

What causes code P0341?

What Does the P0341 Code Mean? Diagnostic trouble code P0341 stands for “Camshaft Position Sensor “A” Circuit Range/Performance (Bank 1 or Single Sensor).” It is triggered when the powertrain control module (PCM) detects a problem with the signal being sent by the camshaft position sensor.

How do I fix error code P0335?

What repairs can fix the P0335 code?

  1. Crankshaft sensor replaced.
  2. Repair or replace wiring harness.
  3. PCM replacement.
  4. Signal plate replaced.
  5. Engine timing belt or chain fixed along with any mechanical damage from this.

What happens when your camshaft sensor goes out?

Poor Drivability A failing camshaft position sensor begins losing its ability to quickly transfer data. Mismatched fuel delivery and ignition timing, even if off by a few milliseconds, will cause your vehicle to sputter, accelerate poorly, lack power, stall or even shut off.

Related Post