How do you hide under cabinet light wires?

Cable Protectors One way to do this is by bundling the wiring carefully and compactly into a bundle and then using tie wraps to hold it in place. You can then stick it the underside of the cabinet using staples (being careful of course not to pierce the wiring and ruining all your hard work).

Table of Contents

How do you hide under cabinet lights?

RECESSED FLOOR WALL CABINETS This is done by raising the floor or bottom of the cabinet upwards, so the cabinet door hangs past the bottom floor of the cabinet. This remaining area or void is perfect to conceal puck or LED strip under cabinet lighting when the cabinet door is closed.

How do you connect under cabinet lighting?

Run a piece of 12/2 nonmetallic electrical cable through the cable clamp of the first fixture, through the holes in the cabinet, and into the next fixture. Repeat as necessary for each fixture. Have at least 6 inches of cable in each fixture.

What connector do you need for LED lights?

The Single-Color LED strips need a 2 pin LED extension cable. The cables themselves finish off at either end with common 2.1mm size barrel plug adapters that are used with all single-color strips and dimming controllers.

What is the Best Lighting for under kitchen cabinets?

UltraPro 24in. Direct Wire LED Light Fixture, Selectable White, Selectable Brightness, LED Light UltraPro 24in. Direct Wire LED Light Fixture, Selectable White, Selectable Brightness, LED Light

How to install hardwired under cabinet lighting?

Disconnect the power. Locate the correct breaker and turn off the power supply to the switch outlet where you’re going to connect the lights.

Attach the lights. Position the lights according to how you laid them out earlier.

Cut the wall.

Run the wire.

Run the cord.

Connect the lights.

Wire the switch.

Cover your work.

Test the lights.

Patch things up.

How to install custom under cabinet LED lighting?

Before starting,be sure to turn off all power to the cabinet location at your home’s fuse/breaker box before working with electrical systems.

Plan the wiring so as many holes as possible will be covered when you are done.

Examine each light to determine exactly where the cable will enter and exit.

How to wire under cabinet LED lighting?

Splice the white wires together.

Attach each of the black wires to a single-pole switch (don’t use a dimmer with fluorescents).

Connect the ground wire to the switch and to the box if it’s metal.

Wrap the body of the switch with electrical tape so the terminals are covered.

Shut off power to the receptacle or junction box that will supply the power.

How do you hide under cabinet light wires?