What does Club Car onboard computer do?

What does Club Car onboard computer do?

Club Car uses an On Board Computer (or OBC) to monitor and control various functions of their carts. It functions as a Go/No Go control for the charging and drive systems. If the OBC detects a problem in either the charging or drive system, it will shut that feature off.

How do you bypass a Club Car on your computer?

And that if you have a ds. That’s all you need to do. And get you a charger a bypass charger and you should be done.

Where is the on board computer located on the Club Car golf cart?

And it will go through a little component it’ll look like this it’ll. Be black you could be gray. Or if you’d be faded.

How do I test my Club Car computer?

How to Test Club Car Precedent Controller?

  1. Connect a voltmeter to the negative terminal on the battery.
  2. Connect the voltmeter to the M terminal on the controller.
  3. Push down on the golf cart pedal.
  4. A clicking sound should be heard.
  5. The batteries show a full charge.

How do I know if my club car has an OBC?

If you have an OBC(on board computer) the wire will come off of that negative wire and through the middle of a small box about 4″ inches square. The small box is the OBC. If your negative wire comes off of the batteries and directly to the motor or anywhere else it does not have an OBC.

Is there a reset button on a Club Car golf cart?

How do you reset the motor on a club cart? First, you’ll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor.

Where is the reset button on a club car golf cart?

It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again.

What year club cars have OBC?

1995

Since 1995, 48 volt Club Cars come with an OBC. The OBC is a small device that is wired into the golf cart that’s purpose is to regulate the batteries charge.

How do I know if my golf cart controller is bad?

How Do I Know if My Speed Controller Is Bad?

  1. The connection of the motor wires to the controller can be incorrect.
  2. Shuttering or shaky driving.
  3. While driving, there are sudden increases in speed.
  4. Taking a break and refusing to begin.
  5. Sudden and unanticipated sluggishness.

How do you bypass OBC on a club car?

To bypass the OBC you will need to connect a 12 gauge black wire from the negative terminal of this battery to where the black wire attaches to the back of the receptacle. That’s it folks; you’re done!

How do you diagnose a golf cart problem?

There are a few simple problems that you can fix yourself that will not necessitate professional maintenance.

  1. Test the wall socket where you charge your cart.
  2. Expose your golf cart batteries.
  3. Test the batteries for voltage.
  4. Replace dead batteries.
  5. Expose the motor for inspection.
  6. Reset the motor.
  7. Test the cart.

Where is the reset button on my electric golf cart?

Identify your main battery supply (usually the largest battery) on your motor. Check around this supply for a small red button that may or may not be labeled “Reset”. Press and hold this button for a few moments and then release it to reset the motor.

Why is my golf cart not firing?

First, try this: turn the key switch on, hit the accelerator, and check for a clicking noise. If you don’t hear clicking, it’s time to take a look at your cart’s batteries. Make sure the battery is fully charged and the terminals are cleaned and secure. Next, see how the water level in the battery is holding up.

How do I know if my Club Car has an OBC?

How do you bypass OBC on a Club Car?

Where is the motor reset button on a Club Car?

How do I know if my Club Car OBC is bad?

NOTE: (Note: If you have any (any) corrossion on or around the OBC or any wires leading to the OBC have corrossion or are burnt or darkly discolored due to heat – your OBC is most likely bad. However, your OBC may still be bad if everything appears to looks good visually, so you will need to test.)

Can you remove OBC on a club car?

What are the most common problems with electric golf carts?

5 Common Electric Golf Cart Problems and How to Solve Them

  1. Troubleshooting Batteries. Like any electric vehicle, the battery is often the root of the problem.
  2. Ignition or Motor Issues.
  3. Solenoid Woes.
  4. Faulty Direction Switch.
  5. No Speed Control.

Where are the fuses on a Club Car golf cart?

In a 1997 Club Car, the fuse is located in the electrical components black box that is present near the battery. On the other hand, in a 2005 Club Car Precedent, the fuse is connected to a blue wire under the golf cart seat.

How do you reset the motor on a Club Car DS?

Is there a reset button on an electric golf cart?

Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn’t repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.

How do I know if my golf cart fuse is blown?

You’re getting ready for a day on the course, when you notice that the lights on your golf cart don’t seem to be working. If the engine still turns over and everything else is working right, you probably have a blown fuse on your hands.

How do you tell if a fuse is blown?

Remove the fuse from its holder. In some cases you may need a small screwdriver to unscrew the fuse holder cap. Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.

Where is the reset button located on a Club Car golf cart?

Related Post