Can you make a 4WD 4L60E to 2WD?

Can you make a 4WD 4L60E to 2WD?

You will need the 2wd output shaft and tail housing. You will have to essentially rebuild the transmission to install this. Your rear driveshaft will now be too short, so plan on getting a new one or going to the junkyard.

Are 2WD and 4WD 4L60E the same?

The main difference between a 2WD transmission vs a 4WD transmission is the output shaft. The Output shaft of a 4WD is shorter than a 2WD version. The 4WD transmission is also designed to mate up with a transfer case to engage 4WD and Lo-range (4L).

Which 4L60E are interchangeable?

Both 2wd and 4wd versions of the 4L60-E can be used equally well, and there are no inherent advantages to either one once you have installed our adapter assembly.

Can you make a 4L60E without a computer?

Externally, all it needs is a 12-volt source and an engine-vacuum reference. However, if your trans is, in fact, a 4L60E, running it off a computer is mandatory. On “E” transmissions, the computer controls everything: TCC lockup, gear changes, shift quality and firmness, and line pressure.

How do I change from 4WD to 2WD?

It’s easy to shift between four-wheel drive (4WD) and two-wheel drive (2WD) in your car.
…
Here’s how.

1. Slow your vehicle to a crawl (preferably 1-3 mph).
2. Shift your transmission into neutral.
3. Turn the transfer control case (the shifter that controls 2WD and 4WD) into its desired position.
4. Put the vehicle back in gear.

How many splines does a 4L60E have?

27-spline

The 4L60E is an electronically controlled version of the 4L60 that retains the 27-spline output shaft and has a 30-percent overdrive. Its overall length is the same as the 700-R4/4L60. The 4L80E uses the larger 32-spline output shaft and offers the highest torque capacity (over 700 ft-lbs in the aftermarket JET model).

Can you make a 2WD transmission 4WD?

The main differences between these two units lie in the fact that the 2WD output shaft is longer than the 4WD version and 4WDs are connected to a transfer case. Some carmakers manufacture their 2WD transmissions in such a way that they can be transformed into 4WD models.

Does a transfer case do anything in 2WD?

Two-wheel transmissions have no transfer case.

What years do 4L60E interchange?

700R4/4L60E/4L65E Year Ranges

Is a 4L60 and 4L60E the same?

The TH700R4 was renamed “4L60” (RPO MD8) following the new General Motors naming convention when the electronic version, 4L60E (RPO M30), was phased in as the 4L60 was being phased out. This happened in 1993 for trucks, vans, and SUVs, and 1994 for rear wheel drive passenger cars.

Is 700R4 and 4L60E the same?

You can’t tell the difference between a 700R4 and a 4L60E by the oil pan as they are nearly the same. If the transmission has a large 18-pin electronic connector above the passenger side pan rail, it’s a 4L60E, as seen here. If it has a cable connection near the cooler lines on the passenger’s side, that’s a 700R4.

How do I get my truck out of 4 wheel drive?

If your truck is stuck in 4wd low, follow these steps:

1. First, put your truck into neutral and wait ten seconds or longer.
2. Next, shift your truck gear into 4wd high and wait another ten seconds or longer.
3. Now, shift your truck into 2wd.

Is it OK to drive in auto 4WD on the highway?

Although not always optimal for efficiency and wear of your vehicle 4wd driveline, AUTOMATIC 4 HI can be used on any road condition without risk of damaging your vehicle.

What year 4L60E are compatible?

700R4/4L60E/4L65E Year Ranges

How many types of 4L60E transmissions are there?

Spotter’s Guide: 4L60E Transmission

How much is it to convert a 2WD to 4WD?

Most of the time, converting 2WD to 4WD is not worth the time or effort. But you can do it if you have the means. On average, it can cost between $10,000 to over $25,000 to convert a 2-wheel drive to a 4-wheel drive. The project requires a lot of custom work and is easier for cars that already have a 4WD version.

What does divorced transfer case mean?

A divorced or independent transfer case is completely separate from the transmission. It is located further down the driveline than a married transfer case and connected to the transmission output shaft by a short driveshaft.

How many different 4L60E transmissions are there?

Spotter’s Guide: 4L60E Transmission

How much horsepower can a 4L60E handle?

Their Stage 2 Pro Race transmission can handle gobs of power while their Invincible Black Edition 4L60E trans can support over 1,000 ponies.

Which is better TH400 or 4L60E?

Much to our surprise, the most significant difference between the TH400 and the 4l60E transmission is the first gear ratio — the 4L60E has a 3.06 first gear, 1.62 second, 1.00 third, and a . 70 overdrive. The TH400 and 4L80E both come with a 2.48 first gear, 1.48 second, and 1.00 third gear.

How much HP can a 4L60E handle?

Is the 4L80E better than the 4L60E?

The Bottom Line
The 4L60E vs 4L80E performance transmission differences are numerous. And these differences show that the 4L80E is the better transmission of the duo. However, it’ll cost you more to acquire this unit compared to the 4L60E and the latter is also easier to find.

How do I put my 4WD back into 2WD?

Q: How do I shift between 4WD and 2WD?

1. Slow your vehicle to a crawl (preferably 1-3 mph).
2. Shift your transmission into neutral.
3. Turn the transfer control case (the shifter that controls 2WD and 4WD) into its desired position.
4. Put the vehicle back in gear.

Can 4WD ruin transmission?

Driving in 4Hi on Dry Pavement
Drivetrain binding can result in all sorts of expensive damage from damage to u-joints, yoke failure, driveshaft twisting, and transmission torque build-up causing major damage to the internal gears.

How fast can you go in 4 high Chevy Silverado?

Conclusion. The 4 High Chevy Silverado allows you to drive at a maximum speed of 55 mph. This is because the Chevy Silverado has a strong engine that can handle this kind of speed. It is also equipped with a strong transmission that will not break down while driving at high speeds.