Which fuel line goes to the primer bulb?

Which fuel line goes to the primer bulb?

The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb. The return line (blue) comes from the long post on the back of the primer bulb and goes into the bottom of the fuel tank.

How do you put fuel line in a weed eater gas tank?

You find your hands slipping you can use a rag. Now as soon as you can see the fuel line protruding in the fuel tank I’m going to reach and grab it with needle nose pliers.

What size is Weed Eater fuel line?

The fuel line has an outer diameter of 9/64th inches and an inner diameter of 5/64th inches. The length of the fuel line is approximately 2 feet.

How do you clean the fuel line on a Weedeater?

You don’t need anything fancy to clean the fuel filter; use a brush, dish soap, and water. Allow the filter to soak in the soapy water for a few minutes. Give it a good scrub and rinse it until the water runs clear.

Which fuel line is the return line?

The vapor-return line normally runs from the fuel pump or the fuel filter to the fuel tank. This vapor-return line is connected to a special outlet in the fuel pump. Any vapor that forms in the fuel pump returns to the fuel tank through this line.

Where does the fuel line go on a carburetor?

CORRECT FUEL LINE ROUTING AND BENCH TESTING 2 & 4 …

Can you replace the primer bulb on a Weedeater?

Weedeater , Weed Wacker Primer Bulb Replacement – YouTube

What size is Homelite trimmer fuel line?

This product is only available through retailers or servicing dealers. The 07-266 Fuel Line has an inner diameter of 3/32 of an inch and an outer diameter of 13/64 of an inch.

Why does my trimmer dies when I give it gas?

Why does my weed eater die when giving it gas? The most common causes of a weed eater dying when throttled are fuel issues, insufficient air intake, or problems with the exhaust. You should follow the path that the fuel travels to identify the issue.

Where does fuel return line go?

The Fuel Return Line should be at least the same size, or one size larger than the supply. Make sure there are no sharp bends or kinks. The return line should direct fuel close to the bottom of the tank and away from the pickup.

What happens if you block the fuel return line?

If the fuel return hose becomes blocked or kinked it may cause the carburetor to flood from excessive fuel or pressure buildup. A flooded carburetor may cause engine stalling and hard starting until it is cleared, or enough fuel has evaporated.

What does the fuel line connect to?

Most vehicles have rubber fuel hoses connecting the fuel pipes on the chassis to the fuel pump or carburetor on the engine. Rubber hoses are flexible and can be cut to length as required, but they have a tendency to perish over time and can rub through if not properly secured.

Can I bypass the primer bulb?

A primer bulb aids in the cold starting of your engine. If it gets damaged, it can be bypassed simply by blocking the line which connects it to the carburetor.

What causes primer bulb not to prime?

When the primer bulb isn’t working, it may be a problem with the bulb itself, with the fuel lines that feed fuel to the bulb or both. Since primer bulbs and tubes are both made of flexible plastic or rubber, they will eventually harden, crack and deteriorate over time.

Who makes Homelite string trimmers?

John Deere acquired the brand in 1994. Techtronic Industries acquired Homelite from John Deere in 2001.

How do you change a fuel tank on a Homelite trimmer?

Replacing the Fuel Tank (Homelite Part # 308675051) – YouTube

When I open the throttle the engine dies?

The most likely culprit is a dirty or clogged air filter. Issues with your fuel pump or fuel filter can also cause your engine to idle then die with any throttle. If you have an older car, it could also be a bad carburetor.

Why does my trimmer bog down?

A dirty or damaged spark plug can cause it to misfire causing the string trimmer to run rough. A loose spark plug wire or incorrect gap can also be responsible for a poorly running string trimmer that bogs down. Remove the spark plug using a socket wrench. Check its condition.

What happens when fuel return pipe is blocked?

Does a fuel return line have pressure?

A free flowing return line maintains consistent pressure in the system. Ending the return above the fuel level in the tank, or in the filler neck will cause aeration. This can lead to fuel starvation and pump wear.

Is primer bulb necessary?

A primer bulb is important because it is helps to fill the carburetor with the correct amount of fuel. It does this by pulling fuel through the fuel line. You may need to fix or replace your primer bulb if: It is not creating proper suction.

Why is the primer bulb not filling with gas?

Faulty Primer Bulb

Another cause of the primer’s filling problem could be the bulb itself. Small perforations on the rubber could inject enough air into the fuel system to make the suction too weak. Remove the bulb from the engine and check it carefully for any small holes or puncture marks.

Did Homelite go out of business?

Deere & Company announced on Nov. 16, 2001 that it has sold its Homelite consumer products business.

What is the fuel mixture for Homelite trimmer?

Fuel Mixture
This Homelite gas trimmer runs on a 50:1 mix of unleaded automobile gasoline and two-cycle engine oil. That is equivalent to 2.6 fluid ounces (80 ml.) of oil to one gallon of gasoline or 4 tsp. (20 ml.)

What size fuel line does a Homelite trimmer?

The 07-266 Fuel Line has an inner diameter of 3/32 of an inch and an outer diameter of 13/64 of an inch.
…
Specifications, Details & Support.