Can you replace staked u-joints?
Replacement Staked-In U-Joints Our staked in replacement ujoints convert the staked ujoint to an inside c-clip ujoint. Use the filters below to help narrow your selection. Free Shipping on all orders over $100.00 within the USA.
What does 1350 u-joint mean?
Each series has a very specific cap diameter and overall joint width. Normally the larger the U-Joint the stronger it is. The 1310 to 1350 U-Joint Conversion is a mix of two different series specifications on the same u-joint so that that different sized yokes and driveshafts can be connected.
What is the difference between 1310 and 1350 u-joints?
Size and strength. The 1310 series joint is what you would expect to find stock in most Jeep or small trucks. A 1350 series joint/shaft is what you might find in many full size trucks. While it’s not 100% accurate, you could say that a 1310 is a “half ton” joint and a 1350 is a “one ton joint”.
Are all 1350 u-joints the same?
Standard u-joints sizes are classified by series, with each series having specific cap diameter and overall joint width. Typically speaking, a higher series number translates to a stronger joint….Understanding U-Joints.
| Series | 1350 |
|---|---|
| Cross Width | 3.625 (3 5/8”) |
| Cap Diameter | 1.188 (1 3/16”) |
| Spicer P/N | 5-1350X |
What are staked in U joints?
Snap rings and staking are the two most common retention methods used to retain bearing cups to the yokes and simultaneously center and align the axes of the shafts. Staking operations use expensive machinery to center the bearing cups and yokes, and then deform the yokes to secure the bearing cups in position.
Is 1410 U-joint stronger than 1350?
Size comparison between the 1310, 1350, and 1410 series U-joints. “A 1350 series joint is a bigger stronger joint,” Woods explained.
How much drive shaft angle is too much?
Ideally, both driveshaft-operating angles will be 1 to 3 degrees. Anything over 3 degrees at the rear axle will shorten your universal joint’s life and could create vibration. If your angle is larger than 3 degrees, you must make sure not to exceed max driveshaft RPM as shown on this Spicer table.
Does Subaru have Ujoint?
Ford, Chrysler, GM, Honda, Mazda, Nissan, Subaru, Toyota, Jaguar and BMW all have models utilizing staked in universal joints. The Mazda Miata and virtually all Subarus have those joints.
How long does it take to replace a u-joint?
On a typical labor book, a U-joint replacement is one or two labor hours, meaning that a $25 part can cost substantially more once someone else installs it for you and charges around $100/hour.
What is the minimum U-joint working angle?
½°
Operating angle Most driveline companies recommend operating angles of 3° or less for maximum u-joint life. There should be a minimum of ½° to allow the needles to rotate. The higher the operating angle, the more likely your vehicle will develop a vibration at high driveshaft speeds.
How much does it cost to have AU joint replaced?
The u-joint replacement cost is estimated between $225 and $300. Labor makes up about $100 to $125, while the parts should be between $125 and $200. However, these prices vary based on what make and model vehicle you drive.