How long should a method feeder hook length be?
4ins
4ins. This length gets a lot of use on commercials in different scenarios. The obvious one is the Method feeder. It needs to be short so that the fish takes the bait, attempts to move, and instantly feels the weight of the feeder before it hooks itself and bolts off.
What size hooks for method feeder?
The hook is a size 16 for fishing a banded 6mm Robin Red pellet or an 18 for a single dead maggot hookbait “When fish feed on the Method, they are not after the hookbait necessarily, they simply come into contact with it as they look to slurp up the feeder’s payload,” the Dynamite Baits’ backed matchman continued.
How far should the hook be from the feeder?
The typical length of a hook link, at least at the start of a days feeder fishing, is 24 inches. Measure 24” of line from the hook and double it over at that point.
How long should my hook length be?
OPINION differs as to how long a hooklength should be. Some canal anglers use hooklengths as short as four inches. Other anglers fishing slow-sinking baits like maggots and casters on clear water venues, make theirs as long as 30 inches. If you’re tying your own hooks, a 12-inch hooklength is a good place to start.
How long should you leave a method feeder?
Usually, a liner develops into a bite so I’ll leave the feeder out for a maximum of five minutes and then recast. Often, the noise of the feeder landing and the bait being emptied will spur fish into feeding, so don’t wait too long for that next cast.
How do I set up a method feeder rig?
How To Set Up A METHOD FEEDER – YouTube
How often should you cast a method feeder?
How often should I cast a method feeder? – You should be regularly casting your feeder out, this is not like bating a spot and waiting for the carp to come in. Every 30 minutes is a good guide but on some waters, you can cast as often as every 5-10 minutes to get more bait in and find the right spots.
How do you rig a method feeder?
How To Tie a Simple Method Feeder Rig – YouTube
How do you get hook lengths the same length?
TACKLE ROOM TIPS – How To Tie Hooklengths – YouTube
Should hook length be stronger than Main Line?
It doesn’t matter what type of line it is.
What bait is best for method feeder?
Best Hook Bait for Method Feeder Fishing – Top 5
- Boilies. No carp baits list would be complete without the boilie.
- Sweetcorn. Another great bait for carp fishing and arguably the most versatile is sweetcorn.
- Pellets. Another conventional and widely used hook bait is the pellet.
- Maggots.
- Pop-up.
Do you need to strike with the method feeder?
Securely place the rod on rests angled down to the water surface and wait for a bite – this will be obvious as the fish will bolt when they feel the feeder. Just lift he rod into the fish – no need for a firm strike to set the hook.
How do you catch a big carp on the method feeder?
HOW TO CATCH BIG CARP ON THE METHOD FEEDER! (With Warren …
How long should I leave method feeder for?
Why use braided hook lengths?
Braided rigs are very flexible, offering virtually no resistance to the carp that picks up the braid. They also allow the hook and bait to separate properly and this results in great hook holds in the middle of the bottom lip.
How do you fish with a method feeder?
How To Fish The Method Feeder – 5 Steps To Catch More Fish – YouTube
Can you use maggots on a method feeder?
Maggots are brilliant when the fishing is hard, as anything will eat a maggot. This means I’m able to create activity in the peg, even on the most difficult of days. Pellets are my ‘go to’ bait when loosefeeding over the top of the Method, as it creates a blend in baits, with the large area of feed on the bottom.
How long do you leave a method feeder?
Why do fisheries ban braid?
Using Braided Line is Banned on some Fisheries due to concerns about fish being damaged or killed. There is little evidence to support Braid causing this or in fact, being any worse than Monofilament or Fluorocarbon line use. However, more and more angling clubs and fisheries are banning Braid.
What is best bait to use on a method feeder?
Can you use bread in a method feeder?
Fishing a punch of this on the method feeder is my number one hook bait and I have complete confidence in it. I also use two punches of this on the bomb as change bait. Typically though for the bomb three 10mm pieces of bread is my go to hook bait, along with two 8mm pieces on the feeder.
Which line is better mono or braid?
Mono holds knots better and costs less than braid. It also works better on smaller bait-casting reels because light braid can dig into itself. Florida sailfish and dolphin anglers still use a lot of mono on the troll, and some use it for kite lines because it runs through the clips better.
How often do you change braided fishing line?
Since braided line is so strong and durable, you usually won’t need to change it out more than every couple of years. However, there are two reasons when I definitely recommend putting new line on your reel: The line is frayed. You don’t have enough line left on your spool.
What bread is best for fishing?
WET BREAD. Sliced bread can be made a lot more user-friendly by wetting and compressing it the day before you go fishing. This produces a much denser bait that holds together. First, remove the crusts from a few slices of thick white bread then soak them for a minute in cold water.
What is a bread bomb?
Bread bombs are designed to firmly hold a lump of bread – similar to using a bait band to secure pellets. The controlled stretch of the Nash bread bombs ensures your bread stays close to your hook, without disintegrating into the water or coming off on the cast.