Which 4L60E are interchangeable?

Which 4L60E are interchangeable?

Both 2wd and 4wd versions of the 4L60-E can be used equally well, and there are no inherent advantages to either one once you have installed our adapter assembly.

What year transmission will interchange chart 4L60E?

700R4/4L60E/4L65E Year Ranges

Are all 4L60E valve bodies the same?

There were updates made to it over the years, so not every 4L60 valve body is the same. Some of the differences include the number of solenoids, as well as the type of 4L60E TCC solenoid and 4L60E 3-2 control solenoid.

Can you swap a 4L60E for a 4L65E?

Upgrading to the 4L65E is advisable in towing applications and where horsepower numbers are up to 500. The 4L60E also uses a four-pinion front planetary carrier, which is more expensive than the rear unit. For cars making over that number, there is a front planetary upgrade as well.

Is a 4L60 and 4L60E the same?

The TH700R4 was renamed “4L60” (RPO MD8) following the new General Motors naming convention when the electronic version, 4L60E (RPO M30), was phased in as the 4L60 was being phased out. This happened in 1993 for trucks, vans, and SUVs, and 1994 for rear wheel drive passenger cars.

Can you run a 4L60E without a computer?

Externally, all it needs is a 12-volt source and an engine-vacuum reference. However, if your trans is, in fact, a 4L60E, running it off a computer is mandatory. On “E” transmissions, the computer controls everything: TCC lockup, gear changes, shift quality and firmness, and line pressure.

Can you make a 4L60E without a computer?

How many check balls in a 4L60E?

GM’s 4L60E transmission valve body contains seven check balls.

What are common problems with 4L60E transmission?

The most common gear issue for a 4L60E transmission is a loss of third gear. This problem typically occurs out of the blue. You can put the vehicle into drive and shift it into second gear without issue, and just as you try to go into third, nothing happens.

Are 4L60E and 4L65E the same?

The 4L65E shares the same exterior parts but have stronger internals such as 5 pinion planets compared to 4 in the 4L60E. 4L60E uses a 6.5″ depth bell with 6 bolts for non gen 3 LS applications and a 7″ depth bell with 7 bolts for LS applications.

Can I replace a 4L60E with a 4L80E?

Upgrading from the 4L60E to the 4L80E is akin to going from a Dana 44 axle to a Dana 60–you’ll add some weight, but also add durability. According to GM Powertrain information, the 4L60E has a maximum engine torque rating of 360 lb-ft and a maximum gearbox torque rating of 610 lb-ft.

What transmission is in a 1994 Chevy 1500 2WD?

4L60E 1993-1994 2WD TRANSMISSION 5.7L 5.0L 4.3L.

Is 700R4 and 4L60E the same?

You can’t tell the difference between a 700R4 and a 4L60E by the oil pan as they are nearly the same. If the transmission has a large 18-pin electronic connector above the passenger side pan rail, it’s a 4L60E, as seen here. If it has a cable connection near the cooler lines on the passenger’s side, that’s a 700R4.

How long does it take to rebuild a 4l60e transmission?

Someone has to know the exact condition of your car to answer this question. The estimated time is about 8 hours. To rebuild the transmission is an additional 6 hours.

What do the check balls do in a 4l60e?

4l60e CheckBall locations are one of the popular designs in the check valves that are an important part of an automatic original transmission. They are responsible for diverting flow into or restricting flow from the specified pathways.

Can a 4L60E be used without a computer?

How do I reset my 4L60E transmission?

How to Reset Your Transmission Control Module

1. First, turn your key to “on.” Make sure your dash lights are visible.
2. With the car on, but the engine not yet started, press the gas pedal all the way down.
3. Hold the pedal down for about 10 seconds.
4. Turn the key off, but don’t remove it.
5. Release the gas pedal.

Is a 4L65E stronger than a 4L60E?

The 4L65E is ideal for such a high amount of torque, as its five-pinion design, 3-4 clutch and improved hydraulic fluid capacity make it a clear winner over the 4L60E for heavier builds with more required power.

What years will a 4L80E transmission fit?

The 4L80-E (and similar 4L85-E) is a series of automatic transmissions from General Motors.
…
GM 4L80-E transmission.

What transmission is in a 1994 Chevy c1500?

Transmission is remanufactured, like new, with all OEM engineering updates, includes the torque converter and no core charge.

What transmission came in a 1994 Chevy Silverado?

4L60E 4L65E 4×4 Z71 1993 or 1994 Stock Remanufactured 4×4 Transmission Chevy, GM, GMC.

Can I run a 4L60E without a computer?

How can I make my 4L60E stronger?

4L60E Mods for Performance Enthusiasts

1. Lay out the important parts on an assembly bench.
2. Rebuild with an improved, thicker sun shell.
3. Use five-pinion front/rear planetary.
4. Use a larger clutch with an input drum reinforcement sleeve.
5. Stamped Steel forward clutch apply pistons.

How much does a new 4L60E transmission cost?

4L60E Transmission – $2,195 | 5-Year Warranty | Money Back Guarantee.

How many check balls does a 4L60E have?